pgbrazerzkidai.blogg.se - Handyprint connect to printer username password

Turn the printer around and with a pen or pencil tip, push the pinhole reset button on the back of the printer for 4 seconds.This is also a useful action to understand if you ever need to verify your printer's network settings in the future. Once the printer is connected to your router, follow the instructions below to print a status sheet displaying the printer's network settings. Connect the other end of the ethernet cable to an ethernet port on your internet router.Connect one end of the ethernet cable to the ethernet port at the bottom of your printer.Turn off the printer by pressing the power button.OPTIONAL: Place the power switch cover over the power button to avoid the printer being accidentally turned off.Push the cover down to snap the lever back into place.Pull the paper out past the cutter at the front of the printer.While doing so, make sure the paper roll stays taut and doesn't unravel. Insert a paper roll with the paper pulling under and out.To open the printer cover, push the lever on the right-hand side of the printer away from you and lift the cover upwards.

Insert the ink ribbon cartridge so that it's lying flat in the printer, then press down to lock it in place.

Turn the knob on the ink ribbon clockwise to tighten the slack.

On top of the printer, press the power button and wait for the blue power light to appear.

Connect the pronged end of the AC cable into an electrical power supply.

Connect the female end of the AC cable into the pronged AC adapter socket.

Connect the male end of the AC adapter into the circular power port at the bottom of your printer.

Make sure you AC cable is not connected to a power supply (unplug if it is).

iOS device installed with the latest Lightspeed Restaurant POS appĬonnect the receipt printer to a power supply.

Router (we recommend routers set up in close proximity to your hardware and printers).

Ethernet LAN cable (long enough to reach your router).

To set up your receipt printer, you'll need the following equipment:

Add the printer to Lightspeed Restaurant.

Connect the printer to your network (for older printer models only).

However, unlike thermal printers, the paper and ink with the U220 are highly resistant to grease and heat in the kitchen.įollow the steps below when setting up your Epson TM-U220 LAN kitchen printer: Compared to thermal-type receipt printers, the U220 is louder and takes longer to print.

This printer uses replaceable ribbon cartridges and prints on standard 3-inch wide plain paper rolls. The Epson TM-U220 printer is a dot-matrix impact printer. Users can then print bar or kitchen tickets to the TM-U220 from an iOS device through a shared network connection. The Epson TM-U220 LAN impact kitchen printer connects directly to an internet router with an ethernet cable.